What is a top loader shifter?
What is a top loader shifter?
A Toploader transmission is a manually shifted gearbox design built in three-speed and four-speed configurations, introduced in 1963 by the Ford Motor Company to replace the BorgWarner T-10.
How does a top loader transmission work?
“The Top Loader four-speed transmission is a fully synchronized type in all gears, except the reverse sliding idler gear that is in constant mesh. All forward-speed changes are accomplished with synchronizer sleeves, instead of sliding gears.
How do I identify a transmission Toploader?
The Toploader 4-speed transmission is identified by a small metal tag riveted to the right side of the case. The first line is the transmission’s ID number. The second line is the serial number.
How much HP can a Toploader handle?
The toploader can handle 700 HP.
What does Toploader mean?
: a worker who places logs at the top of a deck or load.
What does top loader mean?
What is a Ford Toploader 4 Speed?
The toploader 4-speed transmission is of the fully synchronizer type with all gears except the reverse sliding gear being in constant mesh. All forward-speed changes are accomplished with synchronizer sleeves instead of sliding gears.
How do you rebuild a 4 speed Toploader?
Disassembly
- Step 1: Remove Top Cover. The bearing retainer and top cover are removed.
- Step 2: Remove Detent Spring.
- Step 3: Remove Set Screws.
- Step 4: Remove 3-4 Detent Bolt.
- Step 5: Remove Tailhousing.
- Step 6: Take Off Speedometer Gear.
- Step 7: Remove Snap Ring.
- Step 8: Pull 1-2 Shift Rail from Case.
Where is the transmission linkage located on a Ford Toploader?
The shift linkage is mounted directly on the transmission extension housing (Fig. 1, 140K)and enters the driver’s compartment through an opening in the floor pan. A flexible rubber dust boot is provided to seal the driver’s compartment from the exterior. The shift pattern is shown on the top of the gear shift lever knob.
How do you set up a Toploader linkage?
You begin with all linkages in a position so you can place a small Phillips screwdriver through all the setting holes in each linkage arm. Check the pics carefully and you will see how they set up. To start off the adjustment process, put your trans shift levers in the middle of their travel.
What kind of shifter does a top loader use?
The Top Loader three- and four-speed transmissions were tough and durable. Results 1 – 10 of 13 Find Hurst Shifters with Ford top loader Transmission Type and get Free Shifter Installation Kit, Competition Plus, Top Loader, , Ford.
How do you fix a Toploader linkage on a muscle car?
Then, stick a screwdriver, allen wrench, (or the plastic Hurst tool) the same diameter into that hole, push in & wiggle until you’ve captured and aligned all 3 of the ears. Adjust the shifter-end rod pins up or down on the threads until they go into their assigned holes.