Is DEXRON VI compatible with DEXRON?

Is DEXRON VI compatible with DEXRON?

Valvoline DEXRON™-VI ATF is an automatic transmission fluid that can be used in new and old GM transmissions, is fully backward serviceable, and can be used wherever DEXRON™-II and/or DEXRON™-III are recommended.

Can I mix DEXRON 3 and DEXRON 6?

Try not to mix DEXRON-III with DEXRON-VI, only because if you do that you are in fact diluting the DEXRON-VI fluid with a less stable product and therefore throwing away much of the advantage. All you need to remember is that DEXRON-VI is far superior to DEXRON-III.

Can you mix DEXRON 6?

DEXRON-VI can be used in any proportion in past model vehicles equipped with an automatic transmission, in place of DEXRON-III (for instance, topping off the fluid in the event of a repair or fluid change). DEXRON-VI is also compatible with any former version of DEXRON for use in automatic transmissions.

What transmission fluid is compatible with DEXRON VI?

Valvoline MaxLife ATF transmission fluid is 100 percent compatible with the DEXRON VI for mixing or flushing a system.

Is Dexron III the same as dexron VI?

Dexron VI is a lot more stable at higher temperatures and lasts longer. It can also be used to top off dexron 3, however, you can’t use dexron 3 if you already have dexron 6 originally in your trans, or if it has been flushed with dexron 6.

What is the best dexron VI transmission fluid?

#	Product
1	ACDelco GM Original Equipment 10-9395 Dexron VI Automatic Transmission Fluid – 1 gal	Buy on Amazon
2	Valvoline DEXRON VI/MERCON LV (ATF) Full Synthetic Automatic Transmission Fluid 1 QT	Buy on Amazon
3	Amalie (160-72876-56-12PK DEXRON-VI Automatic Transmission Fluid Case 1 Quart, (Pack of 12)	Buy on Amazon

Can you mix ATF 4 and dexron 3?

Use ATF+4 only. Don’t use anything with Dexron/Mercon fluids. These fluids will cause TCC slippage/chatter problems plus wear out your transmission sooner than you would like for. The slipping could also be due to the bands needing adjustment.

Is dexron 6 full synthetic?

Valvoline DEXRON-VI ATF is a full-synthetic transmission fluid formulated with advanced additive technology to meet and exceed the requirements of the General Motors’ DEXRON-VI specification.

Is Dex Merc the same as dexron VI?

Dex/Merc would be fine. Dexron VI is listed by GM as backward compatible, but is thinner than original Dexron III.

Can you mix ATF 4 and Dexron 3?

What does cam2 Dexron-VI Full Synthetic ATF do?

CAM2 DEXRON®-VI Multi-Vehicle Full Synthetic ATF provides additional oxidation control required for extended drain intervals, excellent low temperature performance for fuel economy, and superb shear stability.

What’s the difference between Dexron III and Dexron VI?

Dexron-III and Dexron-VI are both under the same trade name for a group of technical specifications of Automatic Transmission Fluid (ATF) created by General Motors (GM). This series of oil is made with less reactive, more stable hydrocracked oil base that is very less prone to make contact with the heat or friction.

When was the Dexron 3 ( H ) specification introduced?

Introduced in 2003, GM’s Dexron III(H) specification (GMN10055) replaced III (G). The (H) is an additive package for an updated friction modifier and with an oxidatively stable base oil (group 2).

What’s the difference between DEXRON and Hydra Matic?

GM ATF Change Interval under “Normal Driving” Conditions* Fluid Specification Miles 1940 Hydra-Matic 1940 Hydra-Matic 5,000 5,000 1949 Type “A” 1949 Type “A” 10,000 10,000 1957 Type “A” Suffix “A” 1957 Type “A” Suffix “A” 15,000 15,000 1967 Dexron (B) 1967 Dexron (B) 24,000 24,000